PRESTIGE DM FDH+R12 FDH AL
MR – mounting rail
The mounting rail is manufactured by calandering of 0,6 mm sheet steel, surface coated
with white polyester resin paint. Rail is available in 2 lenghts (double-body and triplebody)
for lamps FD or FDH. It is available to order single-body mounting rail on request.
The wiring of 5x1,5mm2 or 7x1,5mm2 cross-section can be installed in the profi le. It is
possible to order wiring with 2,5 mm2 cross-section on request. Ends of conductors
installed in the mounting rail are ended with the axial connector, which allows conductive
continuous connection of the mounting rails without any tools. The connectors, that are
part of wiring, allow simple clamping of luminaire bodies to the mounting rails.
Wiring for the Prestige system is fi tted at the factory and prepared for a rapid electrical
installation. Trunking systems with built-in conductors provides big fl exibility. Prestige
system have electrical connection points for mains, lighting control and emergency
lighting supply at pre-defi ned points – in distances for FD 58W or FDH 35/49/80W
fl uorescent lamp. For simple to complex confi gurations, the mounting rails feature three,
fi ve or seven-conductor wiring with 1,5 mm2 cross-section. Cross-section 2,5 mm2 is
available on request. If emergency lighting is rerquired in the lighting installation, some
of lighting fi xtures has to be equipped with emegency unit, which needs extra conductor
for battery supply.
DEVICE MOUNT FDH
Device mount for FDH fl uorescent lamps is normally installed by using of a mounting rail.
Device mount is manufactured by calandering of sheet steel, surface coated with white
polyester resin paint. Device mount is available in single and twin lamp version, where
both versions can use mostly the same optic. Device mount is equipped with 2 clamping
mechanisms which allow simple gripping of the device mount to the mounting rail. By
using of these clamping mechanisms it is also possible to fi x refl ectors to the device
mount without any tools.
The connector placed on the gear tray is used for simple electrical connection of the
lighting fi xture to the mounting rail. This connector also allows simple selection of the
phase in three-phase system (5 or 7-pole electrical connection). Phase selection is made
by repositioning of movable contact into the required position. Additional free contatcts
allow confi guration of a standard lighting fi xture into an emergency luminaire or into a
DM FDH can be equipped with an electronic ballast or with a dimmable electronic ballast
(analogue or digital). Emergency version is available on request.
In case of missing device mount DM, arose empty gap in mounting rail can be covered
with DM cover.
It is required to make a separate order for lamps.
R12 FDH AL
Reflector is made of pure anodized aluminium, high gloss. Light distribution direct, wide
angle. Designed for one or twin fl uorescent lamps FDH. Ideal for middle – high mounting
installations which require high illumination levels and low energy consumption.