Recessed downlighter EDLR with LED
Recessed downlighter, diameter 235 mm with LED module, comprising reflector housing and gear tray. Protection rating on the room side IP 40, ceiling side IP20. Electronic converter for LED, 220-240 Volt,
0/50-60 Hz and internal connector block 3x2.5mm².
Rigid mounting ring in die-cast metal with toolless clamping mechanism for ceiling mounting and fixing brackets for the reflector. Toolless mounting of the decor ring and accessories. Decorative ring made of white polycarbonate with bayonet fitting. Functional module in white polycarbonate for mounting the reflector using the bayonet fitting. Reflector made of pure aluminium. Diffusor made of transparent polycarbonate with internally satinised polycarbonate to protect the LED, clips into the functional module.
Gear tray plate made of galvanised steel, accommodates all electrical components, mains connector block, cable strain relief and connecting
cable to the LED module. Clip-on heat resistant polycarbonate cover.
In addition to the standard fixing clamps for clamping thicknesses from 0 to 40 mm, special accessory fixing kits such as panel mounting kits, reinforcement plates, cast concrete housings, plaster rings, inclined mounting kits or semi-recessed mounting kits can be ordered.
EDLR 235/... SMT
Diameter 235 mm. Matt narrow-beam reflector made of anodised pure aluminium. LED covered by transparent polycarbonate cap with slight inner matt effect (LEDs visible). Outside of the cap olished.Fitted with RIDI LED module, colour rendering index at least Ra80, colour temperature 4000K (…-840) or 3000K
(…-830), 2000, 3000 and 4000 lumen with passive heat sink.