MARANELLO is the wall-mount and pole-top luminaire with symmetrical indirect light distribution.It is operating with ceramic discharged lamp in 3 wattages. The recommended mounting height is between 3000 - 5000 mm.The light source is directed upward by primary reflector and redirected downward by white reflecting disc. The ground surface is illuminated with smooth and uniform light distribution.MARANELLO is suitable to light up the places like square, open area and street where the specific environment accept no glare.Anchor bolt kit for ground installation are available as accessory.
• Fixture is manufactured in compliance with IEC 60598. Electrical protection class 1. IP65
• Head components and wall bracket in high-pressure die-cast aluminium alloy. Other component in corrosion resistant extrusion aluminium S6063 alloy - copper<0.1%
• Pole and ground installation unit are available seperately. Suitable for pole top 105 mm. Special pole-entry on the luminaire for other pole size can be made upon request.
• Nano Ceramic surface conversion, resistant to corrosive environment. Luminiare primarily coated with epoxy resin and top coated with UV stabilized polyester powder and cured in digital temperature controlled chamber at 200°C.
• Impact resistant transparent safety tempered glass. Able to withstand sudden change of temperature up to 250 C.
• Primary reflector in high purity anodized aluminium 99.90%. Secondary reflector in white coated spun aluminium.
• Weather proof and durable silicone gasket. Service temperature -40 to +200 C.
• All external screw is in 316 stainless steel with silicone grease dipping.
• Cable entry for Maranello-Wall Light protected by weather proof IP67 PG11 synthesized rubber grommet for H07RN-F cable 3G x1.0 Maranello-Post Top come with pull-relife device.
• G12 holder in ceramic nickle-coated contact from Vossloh Schwabe - Germany / ENEC approved. For discharge lamp. T270 rating 4/250/5kV.
• Magnetic ballast from Vossloh Schwabe - Germany / ENEC approved. 230V 50Hz tw130. For discharge lamp. Auto switch-off electronic superimposed ignitor from Helvar - Finland / ENEC approved. Ignition voltage 4.5 kV 220-240V 50-60Hz. For discharge lamp. Power factor correction for discharge lamp from Vossloh Schwabe - Germany or from Electronicon - Germany. ENEC approved.
• 1x0.75 silicone rubber insulated cable with fiberglass braid from CET Eletric - Italy / IMQ approved. 2kV / -60 to +180 C service temperature. Double silicone insulation ignition wire. Tinned copper condutor. Impulsive voltage 5kV. Connector in PA6.6 nickle-plated brass insert. 600V/24A. -40 to +130 C service temperature. Cross section 6mm. VDE approved. Maranello-Wall Light come with quick connector in PA6.6 from ADELS - Germany / VDE approved. Rating 16A/250V. Service temperature up to 160 C. Tinned brass contact. Cross section 2.5mm.
Black - RAL9005 (replace last 2 digits on ordering code with 01)
Graphite - RAL7016 (replace last 2 digits on ordering code with 02)
Dark Grey - RAL7037 (replace last 2 digits on ordering code with 03)
Aluminium Silver - RAL9006 (replace last 2 digits on ordering code with 04)
White - RAL9010 (replace last 2 digits on ordering code with 06)